Owner's Manual

EN-10
USB functions(ash memory type)
1.USBashmemory2in1support
2. FAT 12/FAT 16/FAT 32 format supported.
3. USB 1.1 support, USB 2.0 support (For
2.0,speed performance is as USB 1.1)
4.WMAlessupported
5.MaximumnumberofMP3lesFAT32format
supportedis65535les.(Maximumnumber
ofMP3lesNTFSsupportedis1000les.)
Maximum number of folders is 999.
6. Maximum USB capacity support is 8 GB and
best performance with tracks not more than
500, and not exceeding 30 folders.
7. Not all USB devices are compatible with the
unit.
AUX mode
When radio is on, press [SRC] button several
time, to display AUX.
When the radio is OFF but the contact and the
power are ON : If your device detected the Tele-
mute signal (ground A2), the device switch ON
automatically.
When the signal disapeared, the device switch
OFF.
nb: Control the track with the external device
When using AUX mode, only the POWER knob,
the [volume] and [SRC] button can be used.
Timer function
If the device is switched on while the ignition
is on, it then switches off and on again
automatically with the ignition. This is provided
Other functions
that the A7 contact is connected to the terminal
15/30 of the vehicle. If the device is switched
on without the ignition by pressing "POWER",
it switches off again after 120 minutes to save
the battery. The device can then be switched
on again with "POWER".
Caution: When the radio is switched on, the
automatic antenna extends.
Therefore always switch off the device when
the situation requires it (e.g. in a station car
wash).
You can stop this function in the MENU.
SRC Button
Press the [SRC] button to switch from Radio,
USB (when USB is connected), AUX (when
the device is connected), BT audio, AD2P (when
the BT device is connected)
Password entered
Rotate the [volume] knob to select the digits,
press the [ / ] buttons to change the digits.
Once the password is fully displayed, press the
[SEL]buttonatleast2secondstoconrm,the
radio switches to the last tuner mode listened.
If the password is incorrect, "ERROR" appears
on the display. Please enter the password
again. If the user code is lost, contact the After
Sales Service.
PWD OFF/ON: Activating/
Desactivating the security code.
When the unit is switched on, Press [DSP]
button more than 2 seconds then press
[ / ] button several time to select "PWD
OFF/ON" and turn the [volume] knob to select
"ON" or "OFF": the password is activated or
deactivated.
When set to "ON", the radio code will be
requested or if you have disconnected the
permanent + (B + battery), you will have
to enter the password after each time the
battery is disconnected (the default password
is "1234"). If you only turn off the ignition
(+15/30), the code will not be requested.
PWD NEW: Create a new password
You can set a new password for the unit:
Press [DSP] button more than 2 seconds then press
[
/ ] button several time to select "PWD SET",
enter your old password, press the [SEL] button at
least 2 seconds to confirm. If the old password is
incorrect,"ERROR" "AGN" appears on the display,
please enter the password again.
If the old password is correctly entered, "NEW"
is displayed, enter your new password, press the
[SEL]buttonatleast2secondstoconrm."AGN"
is displayed, enter your new password again
and press the [SEL] button at least 2 seconds to
conrm;"SETOK"is;displayed:thecodehasbeen
updated.