Owner's Manual

EN-8
DAB function
DAB Radio Selection
DAB/DAB+ Provides radio programs in digital
sound quality. To access Digital Audio Broadcast
(DAB) press the [SRC] button and select DAB
DAB Service SCAN "Synchronising"
If the antenna is not connected, ""No signal""
will be displayed. If the tuner has never
been used, ""No service"" will be displayed.
Automatic scan:
The radio will initiate an automatic scan of the
DABtransmittersfortherstoperation,orifthe
DAB transmitters is lost.
Manual scan:
In DAB mode, if you want to launch a scan, hold
down the ""BAND/SCAN"" button for 1 second.
The screen will display the message ""SCAN
OK""andwilldisplaythenumbers1to100K
one after the other (DAB block). At the end of
the scan, the screen will display the number of
stations received (e.g. FOUND 39 = 39 stations
found)andwillbroadcasttherststation.
Select DAB group
"Press the [ BAND ] Button to select one of the
available DAB groups:
DAB1 > DAB2 > DAB3. They allow the storage
of 6 stations each"
Tuning a DAB Service
To tune a DAB service push [<< / >> ]
to select the next/previous DAB service.
“Tuning” is shown on the Display, Then the
station is automaticaly broadcast
DAB Service List
"To get an overview of receivable DAB
services . Push [SEL] for 2 seconds to open
the DAB Service List, Rotate the [VOL]
knob to scroll through the list of receivable
stations. Push [SEL] to tune a DAB service
. “Tuning” is shown on the display, then the
station is automaticly broadcast "
Storing DAB Favourites
"There are 3 favorite DAB groups
available (DAB1 -> DAB2 -> DAB 3).
Select DAB1-2-3 where you want to store the
station, then press the preset button for more
than 2 seconds "
Recall Stored Favourites
To recall a preset station, briefly press the
desired button (1 to 6)
Switching automatic between
DAB and FM (DABFMLNK)
When the DAB signal quality drops
signicantly,itispreferedtoswitchandlisten
to the service via FM. Switching between
DABandFM(DABFMLNK)canbedisabled
via the system settings menu.
Note: If the AF indicator is not displayed,
the radio has not found the corresponding
station in FM and can not switch from DAB
to FM and vice versa
Rural / Urban
Press the [</>] button several times to
select RURAL / URBAN. Turn the [volume]
button to select the appropriate tuner mode:
RURAL (poor reception) or URBAN (locations
near emitters).
BT VOL
Adjusts the level of the AD2P-BT relative to
other sourcies (from 0 to +7).
This radio allows manual or automatic
dimming of the display and key buttons.
Select ""DIMMING"" from the setup
menu and select one of the following:
> Select ""OFF"" to deactivate dimming
> Select the ""MANUAL"" attenuation when
the radio is not connected to the vehicle
ignition pin . The change between day and
night mode is done by selecting Settings
menu ""DIMDAY"" or ""DIMNIGHT""
> Select the ""AUTO"" attenuation when
the radio is correctly connected to the
vehicle ignition pin (A6, +12 V lantern
or pilot lights), the lighting will change
when the parking light is switched on.
Select Manual dimming to adjust Brightness
of display and Buttons". Select DIM MAN and
change between day mode and night mode
by selecting “DIMDAY“ or “DIMNIGHT”"
> To adjust Night Brightness of the display
and buttons select “DIMNIGHT”
> To adjust Day Brightness of the display
and buttons select “DIMDAY""