Instruction manual

115
20. CHANGING THE SETTINGS
2. Use the softkeys ([ADD], [DEL] etc.) in
<Customize tab page> to allocate the desired tab
page layout.
•Press [ADD] to add the selected tab at the right-
hand side of the screen.
•Press [INS] in the second page to insert the
selected tab in front of the current tab.
•Press [CNFG] in the second page to replace the
current tab with the selected tab.
•Press [DEL] to delete the current tab.
G
• Tabs, once deleted, cannot be retrieved.
Select a tab type from the "Type" drop-down list.
3. Repeat step 2 to perform further tab allocations.
4. Press [OK] to finish allocating tabs. The allocated
tabs are stored in memory and <Customize> is
displayed. The newly allocated tabs appear in the
relevant measurement screen.
It is possible to customize screen controls in Observation mode to suit the measurement conditions
and the different methods employed by different operators.
• The current screen control settings are retained until they are revised again, even when the power
is cut off.
•Press [CLEAR] in <Customize/Select screen> to return all customized configurations including tab
pages, status bar settings, and softkey allocations to their previous settings.
• Screen control s cannot be set for the "Graphic" tab.
G
• When screen control settings are recorded and registered, the previously recorded settings are
cleared.
20.5 Customizing Screen Controls