Instruction manual
20. CHANGING THE SETTINGS
120
4. Select the desired softkey from <Softkey list> to
allocate to the position specified in step 3.
5. Repeat steps 3 to 4 to perform further key
allocations.
6. Press [OK] to finish allocating keys. The allocated
keys are stored in memory and <Customize> is
displayed. The newly allocated keys appear in the
relevant measurement screen.
It is possible to preset icon allocations of the status bar to suit various applications and the ways that
different operators handle the instrument.
• The current icon allocations are retained until they are revised again, even when the power is turned
off.
•Press [CLEAR] in <Customize/Select screen> to return all customized configurations including tab
pages, screen controls and softkey allocations to their previous settings.
G
• When icon allocations are recorded and registered, the previously recorded settings are cleared.
• When icon allocations are recorded and registered, the setting reflects to star key mode.
I
The following icons can be allocated to the status bar:
• Remaining battery power
• Target display
• Guide light/Laser-pointer
• Tilt
• Communication status
• Input mode
• SIP (Input panel)
• Touch panel
• ppm (atmospheric correction factor)
•Disk
• No icon
20.7
Changing Status Bar Icons