Instruction manual

125
21.WARNING AND ERROR MESSAGES
The following is a list of the error messages displayed by the OS and the meaning of each message.
If the same error message is repeated or if any message not shown below appears, the instrument
has malfunctioned. Contact your local dealer.
A new folder cannot be made in this folder !!
A new folder cannot be created in the selected folder. Select a different location.
Backsight Z coord is Null !!
Cannot compute. Backsight Z coord is set to "Null".
Input the coordinate.
Backup battery dead. Clock display may no longer be correct.
The voltage supplied by the lithium battery either declines or is completely discharged. Ask your
local dealer to replace the battery for you.
Bad condition
The air is shimmering a lot, etc., measuring conditions are poor.
The center of the target cannot be sighted.
Resight the target.
Unsuitable distance measurement conditions when reflectorless measurement is set. When
reflectorless measurement is set, distance cannot be measured because the laser beam is
striking at least two surfaces at the same time.
Choose a single surface target for distance measurement.
C Precautions for setting prism: "11. FOCUSSING AND TARGET SIGHTING"
Bad letter !!
A file name containing special characters such as "*" and "?" is invalid.
Calculation error
During resection measurement the same point is registered multiple times. Set another known
point so that the known point coordinates do not coincide.
Coordinates identical to the known point coordinates observed during resection exist.
During surface area calculation, conditions necessary for calculations are not met. Check
conditions and try again.
An error occurred during calculation.
Checksum error !!
A sending/repetition error has occurred between the total station and external equipment.
Send/receive the data again.
Code error !!
Cannot read/write code file.
Data not found !!
No data found corresponding to input point number.