Instruction manual

127
21. WARNING AND ERROR MESSAGES
New password Diff.
During new password setting, the passwords input twice are different. Input new password twice
correctly.
No data
When searching for or reading in coordinate data or searching for code data, the search stopped
either because the item in question does not exist or the data volume is large.
North/East is null
Coordinates cannot be read in when either the northing or easting value is set to "Null".
No solution
The calculation of the instrument station coordinates during resection does not converge.
Access the results and if necessary, perform the observations again.
Out of range
During gradient % display, the display range (less than ± 1000%) has been exceeded.
During REM measurement, either the vertical angle has exceeded horizontal ±89° or the
measured distance is greater than 9999.999m.
Install the instrument station far from the target.
The instrument station coordinates calculated during resection are too high.
Perform the observation again.
During area calculation, results exceeded the display range.
Receive error !!
Reception failed.
Receive format error !!
Check the received data.
Send error !!
Send failed.
Signal off
The reflected light is not observed when distance measurement begins. Or, during measurement,
the reflected light has weakened or is blocked.
Either sight the target again or, when using a reflective prism, increase the number of reflective
prisms.
Target not found !!
The prism cannot be found within the Search area range.
Reset and sight the prism and perform measurement again.
Temp Rnge OUT
OS is outside useable temperature range and accurate measurement cannot be performed.
Repeat measurement within the appropriate temperature range.