Instruction manual

155
28. REGULATIONS
U.S.A. FCC -Class A
FCC Compliance
WARNING:
Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user's authority to
operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for
a Class A digital device pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
inter-ference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
This transmitter must not be co-located or operated in conjunction with
any other antenna or transmitter.
This equipment complies with FCC radiation exposure limits set forth for
uncontrolled equipment and meets the FCC radio frequency (RF)
Exposure Guidelines in Supplement C to OET65. This equipment has
very low levels of RF energy that is deemed to comply without
maximum permissive exposure
evaluation (MPE). But it is desirable that it should be installed and
operated with at least 20cm and more between the radiator and
person’s body (excluding extremeties: hands, wrists, feet and ankles).
Declaration of Conformity
Model Number: OS series
Trade Name: TOPCON CORPORATION
Manufacture
Name: TOPCON CORPORATION
Address: 75-1, Hasunuma-cho, Itabashi-ku, Tokyo, 174-
8580 JAPAN
243-0036
Country: JAPAN
U.S.A. Representative
Responsible party: TOPCON POSITIONING SYSTEMS,INC.
Address 7400 National Drive Livermore, CA94551, U.S.A
Telephone number: 925-245-8300
Means of conformity
This device complies with part 15 of the FCC Rules, Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Region/
Country
Directives/
Regulations
Labels/Declarations