Instruction manual

10. CONNECTING TO EXTERNAL DEVICES

Off: Omit the [ACK]

• Setting ’(3) and (4) are for an instrument using GTS commands.

2. Select a mode for the OS in the "Bluetooth" tab.

The factory setting is "Slave".

• "Master" cannot be selected when no

companion devices have been registered.

C "Master"/"Slave": "& Bluetooth

connections"

3. Select, in "Link", a companion device from among

the Bluetooth devices already registered in the

OS.

C Registering devices: "PROCEDURE

Registering Bluetooth companion devices"

• Companion devices cannot be selected when

the OS is set as "Slave".

4. Set "Authentication" to "Yes" or "No".

If "Authentication" is set to "Yes" for the OS the

passkey will also need to be input on the

companion device.

5. When "Authentication" is set to "Yes", input the

same passkey as that for the intended companion

device. Even if "Authentication" is set to "No", a

passkey is requested when authentication is set

on the companion device being used.

• Up to 16 numeral characters can be input. Input

characters will be displayed as asterisks (e.g.

"*****"). The passkey was set to "0123" at the

factory.

6. Press [OK] to finish settings.