Instruction manual

13. DISTANCE MEASUREMENT

An angle can be measured at the same time as distance.

PROCEDURE

1. Face the OS in the direction of the target

Use the sighting collimator to aim the OS and

telescope toward the target.

C"11. FOCUSSING AND TARGET SIGHTING"

2. Start measurement.

Press [MEAS] in the first page of Observation

mode to start measurement.

The measured distance data (SD), vertical angle

(ZA), and horizontal angle (HA-R) are displayed.

3. Press [STOP] to quit distance measurement.

• If the single measurement mode is selected, measurement automatically stops after a single

measurement.

• During fine average measurement, the distance data is displayed as SD1, SD2,... to SD9. When the

designated number of measurements has been completed, the average value of the distance is

displayed in the "SDA" line.

• The distance and angle that are most recently measured remain stored in the memory until the

power is off and can be displayed at any time by pressing [CALL].

C Allocating [CALL]: "20.6 Allocating Key Functions"

13.2

Distance and Angle Measurement