Instruction manual

69
15. RESECTION MEASUREMENT
Standard deviation for the northing, easting and
elevation coordinates of each point are displayed
in the "Detail" tab.
8. If there are problems with the results of a point,
align the cursor with that point and press [OMIT].
“OMIT” is displayed to the right of the point.
Repeat for all results that include problems.
9. Press [RE_CALC] to perform calculation again
without the point designated in step 8. The result
is displayed.
If there are no problems with the result, go to step
10.
If problems with the result occur again, perform
the resection measurement from step 4.
• Press [RE OBS] to measure the point
designated in step 8.
If no points are designated in step 8, all the
points or only the final point can be observed
again.
2nd