Instruction manual

16. SETTING-OUT MEASUREMENT

4. Select "SO data setting" In <Setting out> to

display <SO data setting>. In the distance mode

that conforms to your measurement

requirements, enter the included angle between

the reference point and the setting-out point in

"SO.H.ang", and the distance (slope distance,

horizontal distance or height difference) from the

instrument station to the position to be set out in

"SO.Sdist".

• Each time [Shvr] is pressed, the distance mode

changes from "SD" (slope distance), "HD"

(horizontal distance), "VD" (height difference),

and "Ht." (REM).

•Press [COORD] in the second page and input

coordinates in <Key in coord>. The angle and

distance from these coordinates to the position

to be set out will be calculated.

5. Enter values and press [OK] to display the

screen at right.