Instruction manual

16. SETTING-OUT MEASUREMENT
80
6. Position the target on the line of sight and press
[MEAS] to begin distance measurement.
The distance and direction to move the target until
the setting out point is located is displayed on the
OS. The sighting point measurement results
(currently installed position of the target) are
displayed.
• Movement indicator (Red indicates that target
position is correct)
Y : (Viewed from OS) Move target to the left
Z : (Viewed from OS) Move target to the right
YZ: Target position is correct
G : (Viewed from OS) Move target closer
O : (Viewed from OS) Move target away
OG: (Viewed from OS) Target position is correct
Q : Move target upward
H : Move target downward
QH: Target position is correct
• Each time [Shvr] is pressed, the distance input mode changes from "HD" (horizontal distance),
"VD" (height difference), "R" (slope distance), and "SD" (slope distance).
• Press [CNFG] to set setting out accuracy. When the position of the target is within this range
both arrows will be displayed to indicate that the target position is correct.
Arrows indicate direction to move