Instruction manual

16. SETTING-OUT MEASUREMENT

6. Press {ESC} to return to <Key in coord>. Set the

next setting out point to continue setting out

measurement.

To find a point where a target cannot be directly installed, perform REM setting-out measurement.

C"13.4 REM Measurement"

PROCEDURE

1. Install a target directly below or directly above the

point to be found. Then use a measuring tape etc.

to measure the target height (height from the

survey point to the target).

2. Select "Occupy setup" in <Setting out> to display

<Occupy setup>. If necessary, enter data for

Backsight setup.

C"16.2 Distance Setting-out Measurement"

steps 2 to 3

3. Select "SO data setting" In <Setting out> to

display <SO data setting>. Press [Shvr] until the

distance input mode is "SO.Height.". Input height

from the surveying point to the position to be set

out in "SO.Height". If necessary, input the angle to

the point to be set out.

16.4

REM Setting-out Measurement