Specifications

1-18
Baud Rate
This is the baud rate that is used when your MS1400 communicates
with another device through the serial port. Generally, you will want
to use the highest rate supported. Be sure that the baud rate setting
of your MS1400 matches that of the device that it is connected to.
Clone
You can easily transfer the entire configuration from one MS1400
unit to another. This saves you time when configuring multiple units.
First, connect the optional cloning cable between the two MS1400
units. Select CLONE only on the unit that you want to copy the
configuration to. Press OK soft key to begin the transfer. Cloning
copies the configuration information and active channel plan. If you
wish to copy only channel plans, use the Copy Remote Channel
Plan command (see Copy Remote Plan page 1-33).
IMPORTANT: Be sure that the baud rate
setting of your MS1400 matches that of the
device that it is connected to (see Baud Rate
page 1-18).
Diagnostics
Performs hardware diagnostics and defaults stored preferences to
factory presets. Press Enter key to access the diagnostics options.
Factory Default
Sets all stored preferences to factory presets. Press Enter key to
initiate the default operation.
IMPORTANT: All stored settings are lost when
you perform this operation.
Test Display
Exercises all pixels on the LCD for test purposes. Repeated
pressing of the Enter key sequences the display between all pixels
"on", all pixels "off", and the display test screen.