Specifications

NOTE: Only the limits that are enabled in the
selected test point appear on this screen. If
there are no enabled test points, this screen
will not be available. You can however, view
the CHANNEL LIST and CHANNEL
MEASUREMENT screens described below.
The Channel List
Press Sequence soft key or Enter to sequence to the channel list
screen.
TIP: In addition to using the Sequence soft
key and the Enter key, you can also press the
Left/Right Arrows to sequence through the
results screens.
The channel list provides essential information about each channel.
In the list you will find the channel number in the first column
followed by the label. The level of the video carrier is in the next
column. The package in which the channel is contained is displayed
in the fourth column. Finally, the overall limits pass/fail result for the
channel is found in the last column.
The Pass/Fail Indicator
Use the PASS/FAIL indicator located directly above the channel list
to quickly determine whether the highlighted channel has passed
the limits check. If the channel failed, you can identify the reason(s)
for the failure by looking at the symbols that appear in this indicator.
2-4