Specifications

Subscriber Drop
Ground Block
Tap
User Defined
NOTE: Be sure that you have enabled all of
the test points that you are interested in using.
The Cycle Through Test Points soft key is
only available if there is more than one
enabled test point. (see How To Edit Test
Points page 1-20)
When you have selected the limits submenu, the marker information
below the graph is replaced by the overall limit check summary for
channels currently being displayed on the graph. For each limit,
the worst case actual value is displayed along with a pass/fail
status. The results are updated upon the completion of each scan.
Cursor on Analog Channel
Cursor on Digital Channel
IMPORTANT: The limit check results apply
only to the channels currently being displayed
on the graph — not the entire channel plan.
NOTE: Only the limits that are enabled in the
selected test point appear on this screen.
Your MS1400 can indicate the minimum and maximum carrier level
limits on the graph. When the cursor is on an analog channel, video
min and max are used. When the cursor is on a digital channel, the
digital min and max are used. The min and max hash lines will
change as the cursor moves. The out-of-limit portions appears as
diagonal “hash” areas. You can toggle the hash lines on and off by
pressing Toggle Display of Hash Lines key.
2-14