Specifications

New/Edit Location
This screen is where you enter the information for a new or
existing location. Press the Up/Down Arrows to select the item
to be edited. The items that appear in the list depend on the type
of location you have selected. If you regularly perform tests at
this location, you can save it for future use so that you only need
to enter the information once. To do this, press Save soft key
and enter a name for the location. When you are done editing,
press OK to continue configuring the Auto Test.
NOTE: Your MS1400 will remind you when
you have not stored the location. You should
only do this, however, if you think you will
return for another test.
Choose Probe Point
Some location types have multiple points at which you can make
test measurements. If you have selected such a type, this screen
will appear. Use the Up/Down Arrows to choose the appropriate
probe point from the list and then press OK soft key.
Measure Voltage
You can log voltage measurements that you make using your
multimeter. These will appear when viewing or printing the
results of the Auto Test. When you have finished entering the
measurements, press OK soft key.
Compensation
Compensation is added directly to the signal level
measurements. You can use this to compensate for losses
associated with probe points found on certain amplifiers. The
default is the Probe Compensation value specified in Configure.
Enter a different value if necessary. Press OK soft key to
continue.
2-23