Installation Guide

After setting up the faucet, do
the following:
1. Place the filter unit in a
convenient location with
the spout positioned over
your sink. The spout is
designed to swivel.
2. Turn on your cold water and
divert the water through the
filter by pulling out/turning
the knob on the diverter
valve. Water pressure
should hold it in the out
position.
3. Allow it to run for several
minutes to flush out the
normal carbon fines
(blackish specs). Initially, the
water may contain tiny air
bubbles and taste slightly
sweet - this is normal and
harmless, and will clear up
after flushing.
4. To stop the flow, turn off the
cold water at your faucet -
the diverter valve knob will
return automatically for
normal unfiltered water
flow through your kitchen
faucet.
Faucet with inside thread
- enclosed adapter ring and
gasket must be used
Countertop with filter installed
b.
If your faucet has non-standard
threads, you may need to
purchase a special adapter from
your local hardware store.