Installation Guide

1. Turn off water.
2. Unscrew housing from its base.
Note: If the housing seems stuck, soak the base of the housing
for 10 minutes in a mixture of HOT water and a little vinegar.
3. Place Housing upside down on cabinet and remove used cartridge.
3. Check the O ring for wear and tear. (The O ring rests in a groove 1
“down in the housing).
a. If it is worn replace it.
b. If O ring is in good working order,
Note: lubricate it with petroleum jelly to ensure it lies flat
and prevents leaking.
Replacing Your Cartridge
6. Leave the housing on the counter, pick up the base, and screw it
back on tight enough to prevent any leakage. Doing it this way will
prevent the O- ring from slipping loose and causing the filter to
leak. Turn the housing/canister right side up.
Note: Before putting the housing back on, put some petroleum
jelly on the plastic threads this will make it easier to unscrew the
housing the next time you change your filter cartridge.
5. Unwrap filter cartridge
from the plastic wrap. With
your housing’s open end
facing up, place the new
filter into the housing