Manualshelf

Use and Care Manual

ManualsBrandsAncona ManualsAppliancesPro Pyramid Turbo 36 in. Wall Mount Range Hood with Hidden Control and LED in Stainless Steel
10111213141516171819
— 12 —
STEP 11
Mount Range Hood Onto Wall
• Position the range hood’s mounting key holes securely onto the range hood mounting screws.
• Finish screwing in the screws until they cannot tighten any further.
STEP 12
Install Damper
• Place the damper gasket followed by the damper over the ventilation hole on top of the motor body.
• Secure using the four screws (included).
STEP 13
Connect Ductwork
• Attach ductwork to damper. Secure the ductwork with duct tape to make sure joints are secure and air- tight.
• Do not install the duct tape too tightly as this may prevent the damper aps from opening which will overwork the motor
and cause improper functioning of the unit.
• Fasten all connections with sheet metal screws and tape all joints with certied aluminum or foil tape. Use caulking to
seal exterior wall or roof opening around the cap.
STEP 14
Connect to AC
• ConnectACplugintoagroundedACoutlethaving120V,60Hz.Placetheoutletatamaximumdistanceof33-1/2”
(851 mm) from where the cord exits on the hood.
• SEE IMPORTANT INSTRUCTIONS ON THE
FOLLOWING PAGE.
3-Pronged Plug
Ground Plug
3-Prong Receptacle