User`s manual

  <9.GeneralSpecications>
9-21
IM 01C25B01-01E
*6: Applicable for vertical impulse piping type (Installation code 7) and Wetted parts material code S, H, M, and T.
*7: ApplicableforoutputsignalcodeD,EandJ.Thehardwareerrorindicatesfaultyamplierorcapsule.
*8: Applicable for Wetted parts material code S, H, M, and T; Process connection code 3, 4, and 5; Installation code 9; and Mounting
bracket code N. Process connection faces on the other side of zero adjustment screw.
*9: Also see ‘Ordering Instructions’.
*10: Applicable for M, H and V capsules of EJX110A with wetted parts material code S, and all the ranges of EJ130 and EJ440.
Applicable also for EJA110E with option code /HG.
*11: Not applicable for output signal code F.
*12: Applicable only for EJ310 M and A capsules whose upper range value is set as smaller than 53.3 kPa abs.
*13: Applicable for wetted parts material code S; process connection code 0 and 5; and installation code 8 and 9. Not applicable for
option code U1, N2, N3 and M11. Not applicable for EJ120.
*14: Applicable for wetted parts material code S.
*15: Materialtraceabilitycertication,perEN102043.1B.
*16: Applicable for Process connections code 0 and 5.
*17: Applicable for Process connections code 1, 2, 3, and 4.
*18: Applicable for EJA110E, Capsule code F and L of EJX110A, Capsule code B of EJ430 and EJX310A, and all the capsules of
EJX110A with wetted parts maerial code H, M, T, A, D, and B.
*19: Applicable for Capsule code M, H and V of EJX110A with wetted parts material code S.
*20: Applicable for Capsule code A of EJ430 and EJ310.
*21: Applicable for Capsule code H of EJ430.
*22: Applicable for EJ120 and Capsule code L and M of EJ310.
*23: Applicable for EJ130 and Capsule code C of EJ440.
*24: Applicable for Capsule code D of EJ440.
*25: Pure nitrogen gas is used for oil-prohibited use (Option code K1, K2, K5, and K6).
*26: Pure nitrogen gas or pure water is used for oil-prohibited use (Option code K1, K2, K5, and K6).
*27: Applicable only for output signal code E and J.
*28: Thechangeofpressureuctuationismonitoredandthendetectstheimpulselineblockage.SeeTI01C25A31-01Efordetailed
technicalinformationrequiredforusingthisfunction.Thedetectionisforonesideonly.
*29: Applicable for EJA110E, Measurement span code M, H, and, V; and wetted parts material code S. The URL of static pressure range
is also extended to 25 MPa.
*30: OutputstatusatCPUfailureandhardwareerroris−5%,0.8VDCorlessforoutputsignalcodeQ.
*31: The 1 to 5 V voltage output corresponding to 4 to 20 mA current output is applied to output signal code Q which is non-compliant to
NAMUR NE43.