Installation & Assembly

RUN UNDERGROUND WIRE (INSIDE CONDUIT REQUIRED)TO POWER

SOURCE. ALWAYS RUN WIRE THROUGH CONDUIT IN AREAS SUCH AS

FLOWER BEDS, GARDENS, ETC., WHERE FUTURE DIGGING COULD CUT

WIRE CAUSING A FATAL ELECTRICAL SHOCK. NOTE: CONSULT YOUR

LOCAL ELECTRICAL CODE FOR WHAT IS THE REQUIRED WIRING TYPE

WHEN PREPARING THE FOUNDATION YOU NEED TO DIG A HOLE

ABOUT 12” WIDE BY 15” DEEP. AVOID LOCATING THE POLE TOO

CLOSE TO HOUSE TO HELP SPREAD LIGHT MORE EVENLY.DO

NOT LOCATE POLES WITHIN 10’ FROM THE INSIDE WALL OF A

SWIMMING POOL.

AFTER YOU FINISH POURING THE CEMENT YOU CAN BEGIN SETTING

YOUR ANCHOR BOLTS. INSERT BOLTS INTO TEMPLATE LEAVING

ENOUGH THREAD TO SECURE BASE WITH CAP NUTS.MAKE SURE TEM-

PLATE IS LEVEL WITH THE SURFACE.CONSULT THE DIRECTIONS ON THE

CEMENT BAG FOR THE AMOUNT OF TIME NEEDED FOR IT HARDEN.

ONCE YOUR WIRING IS COMPLETE, YOU ARE READY TO POUR

THE CONCRETE.NORMALLY IT TAKES ABOUT A 50 LB. BAG OF

READY-MIX. CHECK WITH YOUR LOCAL HARDWARE TO DETER-

MINE WHAT IS THE BEST CEMENT FOR YOUR GROUND.

PAGE 1

POLE LAMP FOUNDATION INSTRUCTIONS

PAGE 1
WHEN PREPARING THE FOUNDATION YOU NEED TO DIG A HOLE ABOUT 12” WIDE BY 15” DEEP. AVOID LOCATING THE POLE TOO CLOSE TO HOUSE TO HELP SPREAD LIGHT MORE EVENLY.DO NOT LOCATE POLES WITHIN 10’ FROM THE INSIDE WALL OF A SWIMMING POOL. RUN UNDERGROUND WIRE (INSIDE CONDUIT REQUIRED)TO POWER SOURCE. ALWAYS RUN WIRE THROUGH CONDUIT IN AREAS SUCH AS FLOWER BEDS, GARDENS, ETC., WHERE FUTURE DIGGING COULD CUT WIRE CAUSING A FATAL ELECTRICAL SHOCK.
PAGE 2
ONCE THE CEMENT HAS HARDENED PLACE YOUR PRE- NOTE: SOME POLES DO NOT HAVE AN ACCESS PANEL.FOR THIS YOU ASSEMBLED POLE OVER BOLTS AND SECURE WITH THE DEC- NEED TO TILT THE POLE SIDE WAYS, JUST ENOUGH TO MAKE YOUR ORATIVE CAP NUTS.REMOVE THE ACCESS PANEL AND MAKE CONNECTIONS. THEN, PROCEED TO SECURING BASE TO GROUND. YOUR NECESARY CONNECTIONS.MAKE SURE YOU CONNECT THE GROUND WIRE TO AVOID ANY ELECTRIC SHOCK.