User's Manual

SER

S MANUAL FOR BAND SELECTIVE REPEATERS

03P

User'sManual.doc Id.-No.:154999 Page 23 22-Jan-01

4. INSTALLATION

4.1. MECHANICAL INSTALLATION

4.1.1. General

Note: Due to power dissipation the repeater may reach a very high

temperature. Therefore, it is necessary to mount the repeater

vertically to a wall or a mast without additional enclosure. A

clearance distance of one metre above and below the unit should be

kept to provide sufficient ventilation. Between the housing and the

wall, a minimum distance of 20 mm must be ensured.

F Note: The weight of the repeater is

approximately 14 kg in standard

configuration. Only adequate

manpower is allowed to handle

the weight of the system.

F Note: If it is impossible to mount the

repeater with the mounting

brackets due to an uneven

surface (e.g. a bulged wall in a

tunnel), alternative fastening

devices may be used. These

fastening devices must fulfil the

following requirements:

F Note: The external strain must not be

increased by the alternative fastening

devices. Holding devices, which expose

the repeater to enhanced vibration or shock

due to a greater distance from the wall (leverage)

or due to a lower rigidness or stability

(vibration), must not be used.

Note: The repeater’s external strain specifications must not be exceeded,

particularly the exposure to vibration and shock (please refer to the

MIKOM “Environmental and Safety Leaflet” for further detailed

information).

Note: Exceeding the specified load limits may cause the loss of warranty!