User's Manual

U
SER
´
S MANUAL FOR BAND SELECTIVE REPEATERS
MR
X
03P
User'sManual.doc Id.-No.:154999 Page 24 22-Jan-01
4.2. WALL MOUNTING PROCEDURE
Check the suitability of the wall mounting
kit and the wall.
∫ Dismount the mounting brackets which
are screwed to the housing with four
socket head cap screws M8x16 and two
tire bolts.
∫ Use the wall mounting template to mark
the position of the drilling holes. Drill four
holes and screw the mounting brackets to the wall.
∫ Attach the upper two socket head cap screws M8x16 to the repeater housing.
Hang the repeater into the mounting brackets.
∫ Fasten the lower two socket head cap screws M8x16 and the two tire bolts.
Ensure that there is free access to the electrical connections as well as to the
individual units inside the cabinet while the door of the repeater is open (clearance
distance of 1 m is recommended). The approved bending radius of the connected
cables must not be exceeded.
figure 4-1 Installation drawings of a repeater