User's Manual
U
SER
ยด
S MANUAL FOR BAND SELECTIVE REPEATERS
MR
X
03P
User'sManual.doc Id.-No.:154999 Page 31 22-Jan-01
5.2. BOOT PROCESS
As soon as the repeater is switched on, the control module of the repeater starts the
boot process; LE3 displays โPower onโ. The initialization of the hardware is part of
the boot process. The whole process may take up to several minutes.
After booting the system, LE1 turns red for a few moments, then flashes green. LE2
also flashes red and then green. This is just an optical functionality test of the two-
coloured LEDs.
figure 5-1 Control module โ Position of LEDs
Internal
LED LE1
Internal
LED LE2
Internal
LED LE3
Cause
green
Power on
Software booting
Flashes red
for a short
time
Flashes red
for a short
time
green LED test
green green green
Software boot
successful
table 5-1 LED indication during boot process
LE3
LE2
LE1