User's Manual

SER

S MANUAL FOR BAND SELECTIVE REPEATERS

03P

User'sManual.doc Id.-No.:154999 Page 33 22-Jan-01

5.4. REMOTE SETTINGS

After the boot process, the software login is possible. All parameters of the software

can be changed by the provider to optimize the repeater according to the network

system. There are two possibilities how to login to the software:

∫ locally via a VT100 terminal or a PC with VT100 terminal emulation

∫ remotely via a modem e.g. with the Operations and Maintenance Center (OMC)

5.4.1. Local Login

The login via VT100 terminal or a PC with VT100 emulation can only be performed at

the repeater. Open the repeater carefully and ensure that DIP-switch 2 of mode-

switch [1] is in position OFF. Only when DIP-switch 2 is OFF, a local access to the

software on the control module is possible (see chapter 5.3 DIP-Switches).

Connect the terminal or PC to the RS232 interface on the control module by means

of a standard RS232 interface cable (see picture below).

Terminal or PC Control Module SM2009

9 contact SUB-D-connector 9 contact SUB-D-connector

male male

Pin Pin

Check the communication mode at the terminal. If necessary, set the following

parameters:

Bit rate / bit per second: 9600 baud Number of data bit: 8 bit

Parity bit: No parity Stopbit: 1 stopbit