User's Manual

U
SER
´
S MANUAL FOR BAND SELECTIVE REPEATERS
MR
X
03P
User'sManual.doc Id.-No.:154999 Page 34 22-Jan-01
∗ Note: The input is case sensitive, no blanks allowed. The connection will
be torn down after three wrong inputs!
There are two possibilities to login to the repeater software:

Repeater off: The repeater is switched off, the RS232 interface cable is already
connected and the DIP-switch 2 of the mode-switch (1) is set to
positon OFF.
After switching on the repeater, the boot procedure starts. Subsequently, the display
of the terminal shows following report.
-----------------------------------------------------------------------------------------------------------------
AT
MIKOM REPEATER MRXXX – SM2009 -SW: REP 10XX VX.XX
ENTER
<
.
> <
CR
>
TO LOGIN
-----------------------------------------------------------------------------------------------------------------
Please type
<.> (fullstop) and confirm with <CR> (carriage return)
to get to the login orders.
∗ Note: The following step can only be carried out by qualified personnel
in consideration of the health and safety warnings. Pay attention
not to touch devices while the repeater is operating!
 Repeater On: The repeater is operating.
After connecting the RS232 interface cable and changing the mode-switch (1) DIP-
switch 2 to OFF, the display won´t show a report.
Please type
<.> (fullstop) and confirm with <CR> (carriage return)
to get to the login orders.
∗ Note: Sometimes it is necessary to type the <.> (fullstop)-command twice
or three times to get access to the repeater software.