User's Manual

SER

S MANUAL FOR BAND SELECTIVE REPEATERS

03P

User'sManual.doc Id.-No.:154999 Page 35 22-Jan-01

After successful login, the USERID is required.

-----------------------------------------------------------------------------------------------------------------

ENTER USER ID:

-----------------------------------------------------------------------------------------------------------------

Please enter

<UserID1>* and confirm with <CR> (carriage return).

* UserID1 is factory set and can be changed by software

Note case sensitivity and blanks!

Now, the correct password is asked. Following order will be displayed on the

terminal:

-----------------------------------------------------------------------------------------------------------------

ENTER PASSWORD:

-----------------------------------------------------------------------------------------------------------------

Please enter

P-word1

** and confirm with

(carriage return).

** P-word1 is factory set and can be changed by software

Note case sensitivity and blanks!

If the software-login procedure was successful, the input request shown below

displays on the terminal:

-----------------------------------------------------------------------------------------------------------------

MIKOM >

-----------------------------------------------------------------------------------------------------------------

All parameters of the repeater can now be changed to optimize the repeater to the

network system.

5.4.2. Remote Login

A login e.g. via modem at the OMC enables the operator to set parameters and to

query the status of each repeater. This can be done either via a wireless modem or a

PSTN-modem. The access commands to the repeater-software are the same as

described in chapter

5.4.1 Local Login.

If the OMC is used for the remote login, the

input “<.> (fullstop) and <CR> (carriage return)” is skipped and UserID and Password

are requested right away.