Installation guide

INSTALLATION SECTION 3
1. Remove all banding and pry off crate sides carefully so as not to damage the water
heater.
2. Carefully roll/lift the water heater from the crate base.
MOVE WATER HEATER TO PERMANENT POSITION by sliding or walking. Place on plinth/base as detailed previously.
REMOVE CRATE
Do not drop water heater. Do not bump water heater jacket against floor.
Do not bump exhaust flue pipe against crate or other objects. This will damage the heater and cause it to be
inoperable or create nuisance problems.
CAUTION
KEEP APPLIANCE AREA CLEAR AND FREE OF COMBUSTIBLE MATERIALS,
PETROL AND OTHER FLAMMABLE VAPOURS AND LIQUIDS.
This water heater MUST be installed indoors out of the wind and weather.
This water heater must be located in an area where the general public does not have
access to set temperatures.
LOCATION
Corrosion of the internal flue ways and concentric flue system will occur if air for
combustion contains certain chemical vapors. Such corrosion may result in poor
combustion and create a risk of asphyxiation, as well as reducing the life of the water
heater. Spray can propellants, cleaning solvents, refrigerator and air conditioning
refrigerants, swimming pool chemicals, calcium and sodium chloride, waxes and process
chemicals are corrosive. Products of this sort should not be stored near the water heater or
outside by the air intake (if applicable).
CHEMICAL
VAPOUR
CORROSION
13