Installation guide

INSTALLATIONSECTION 3

Installation Procedure

Determine location of flue exit.

1. The Horizontal or Vertical flue kit that has been delivered includes the components as

listed below and on page 21. The concentric flue pipe system includes both the flue

exhaust (inside pipe) and combustion air (outside pipe). The flue pipe may be cut on the

unflared end (end without gasket) as required for the installation.

2. Determine if additional flue components are required for the installation. Refer to the

flue component information on pages 21 and 55 for available optional flue components.

3. Ensure that the flue terminal location complies with requirements described within this

manual and the Local Codes of Practice.

4. Measure the vertical and horizontal distance from the water heater flue connection to

determine the number of components required.

HORIZONTAL FLUE KIT/FITTINGS PACK - 230 LITRE MODELS AWH PART No: B291

SUPPLIED COMPONENTS

Part Description Part Number

Exhaust Outlet Tee c/w Condense Outlet (82500) E860

100mm to Concentric Exhaust Connector (75412) E861

Air intake Tee Piece Connector (82501) E862

Condense Syphon (87436) E863

Horizontal Flue Terminal, 100/150mm (87990) E236

90º Elbow c/w clamp, 100/150mm (87890) E205

Gas Cock - 3/4” BSP C498

Drain Valve - 3/4” BSP C381

Drain Valve Socket - 3/4” BSP C103

Installation, Operation and Maintenance Manual E864

VERTICAL FLUE KIT/FITTINGS PACK - 230 LITRE MODELS AWH PART No: B293

SUPPLIED COMPONENTS

Part Description Part Number

Exhaust Outlet Tee c/w Condense Outlet (82500) E860

100mm to Concentric Exhaust Pipe (75412) E861

Air intake Tee Piece Connector (82501) E862

Condense Syphon (87436) E863

Vertical Flue Terminal, 100/150mm (87969) E866

Gas Cock - 3/4” BSP C498

Drain Valve - 3/4” BSP C381

Drain Valve Socket - 3/4” BSP C103

Installation, Operation and Maintenance Manual E864

HORIZONTAL

AND VERTICAL

FLUE KITS