Installation guide

COMMISSIONINGSECTION 4
For your safety read this section prior to lighting the appliance.
WARNING
1. Always follow manufacturer's instructions when lighting the appliance. Failure to do so
may result in damage to property, personal injury or loss of life
.
2. Before lighting, check all around the appliance area for gas. Be sure to check at low
level because some gas (i.e. LPG) is heavier than air and will settle on the floor.
3. Do not
make any attempt to re-light the appliance if the main burner has
extinguished. W
ait at least 5 minutes to allow for any unburnt gas to disperse.
Ventilate the area if possible.
FOR YOUR SAFETY IF YOU SMELL GAS
1. Turn off gas supply and open windows.
2. Do not operate electrical switches.
3. Extinguish any naked flames.
4. Contact gas supplier if the smell of gas persists.
FOR YOUR SAFETY
Do not store or use petrol, aerosol or other flammable vapours or liquids in the vicinity of
this or any other gas appliance.
USER’S SAFETY
GUIDE
CAUTION! DO NOT OPERATE THE WATER HEATER UNTIL THE STORAGE
VESSEL IS COMPLETELY FILLED WITH WATER, WITH WATER RUNNING FROM
ALL HOT TAPS.
Open the main gas supply cock after all connections to the gas control are completed and
test all connections, using proprietary leak detection fluid.
Filling the Heater with Water
1. Close the water heater drain valve.
2. Open the cold water supply valve.
3. Open several hot water taps to allow air to escape from system.
4. When a steady stream of water flows from the taps. the heater is filled.
5. Close the taps and check for leaks at the drain valve, temperature/pressure relief valve
and the hot and cold water connections.
36