Owner`s manual

10
E
N
ICONS ON YOUR ANGELCARE
®
MONITOR
ICON MEANING FUNCTION AND USE
PARENT UNIT
Power
Press and hold to turn ON or OFF.
Channel key (8 channels)
Press to enter or exit the Channel Selection Mode.
Push the channel button on the Parent Unit. The “--” symbol will appear along
with the In Range icon which will flash. Press the channel selector (top button)
on the Nursery Unit until the night light halo flashes. Select the channel by
gently pushing on the top button on the Nursery Unit (you will see the channel
changing on the Parent Unit). Once the channel is selected, press and hold the
Nursery Unit top button to confirm selection (halo will stop flashing).
Both units are always on the same channel.
If the interference persists, consult the Troubleshooting section.
Temporary mute key
Press to mute the speaker. Parent Unit will not receive sound for 2 minutes.
Press again to reactivate the sound before the 2 minutes are up, if desired.
Up and down
sound volume
Increases or decreases volume on the Parent Unit.
PARENT UNIT’S SCREEN DISPLAY
Nursery Unit
When this icon appear, batteries need to be replaced in the Nursery Unit.
Parent Unit
This icon will be ON only during Channel Selection Mode.
Sound
This icon indicates that the sound transmission is activated. It will flash when
in Temporary Mute Mode.
Battery level
When this icon is clear, the batteries in the Parent Unit are low, and the Parent Unit
needs to be placed on the charger. When icon is clear and flashes, and the
Nursery Unit icon appears, the nursery unit batteries needs to be replaced. When
the batteries are TOO LOW, a “beep” will be heard every 15 seconds . The low
battery warning will continue for 30 minutes before the unit shuts itself OFF.
Sound level indicator
Displays the sound level on the Parent Unit. There are 5 sound levels. Once
you've chosen the desired level with the Up and Down keys, the bars will disap-
pear and will start moving according to the sound transmitted by the Nursery
Unit. The sound level indicator bars allow you to see the level of sound in your
baby’s room. The louder the sounds from baby, the more bars appear.
Channel and Baby’s room
temperature display
When turning ON the Parent Unit then the Nursery Unit, the channel number
will be displayed on the Parent Unit screen for about one minute. It will then
be replaced by the nursery room temperature display (in Celsius).
Note: If the Nursery Unit is ON before the Parent Unit, or if the Parent Unit is OFF
and then turned ON while Nursery Unit is ON, the temperature display will
indicate the channel number until there is a change of temperature.
In Range icon
1) This icon will start flashing on the Parent Unit when the distance between the
units is over the maximum range. A beep will also be heard. To activate this
function, slide the right wing switch up. This option informs you when the distance
between the Nursery Unit and the Parent Unit is over the maximum range of
transmission. To deactivate the In Range function, slide the right wing down.
NOTE: Range: up to 250 meters/ 820 ft (open field); between 80 meters/ 262 ft and
100 meters/328 ft (indoors).
2) This icon will also flash with the channel number on the Parent Unit screen
when in channel selection mode.