User Manual

ManualsBrandsAnhui Sanan Technology ManualsElectronicsSplicing Light

Galaxy Light APP Manual

1、 Connecting products (first use)

Step1：Click on the "+" button in the upper right corner of APP.

Step2: Click on the MAC address of the window lamp.

Step3: The color of the lamp name is blue and the connection is

successful.

2、 Home page:（Dynamic）

Click on the preset dynamic scene, and through the pull-up button below

“ ”, you can change the scene mode, brightness, conversion

speed, timing switch lights.

Summary of content (11 pages)

PAGE 1
Galaxy Light APP Manual 1、 Connecting products (first use) Step1：Click on the "+" button in the upper right corner of APP. Step2: Click on the MAC address of the window lamp. Step3: The color of the lamp name is blue and the connection is successful. 2、 Home page:（Dynamic） Click on the preset dynamic scene, and through the pull-up button below “ ”, you can change the scene mode, brightness, conversion speed, timing switch lights.
PAGE 2
.1 Mode is scene mode switching. There are four modes: soft, jump, random and flicker. 2.2 The existing lamps can be dynamically pushed to other lamps by “ button. 2.3 New Dynamic Scene set.
PAGE 3
PAGE 4
3、 PAGE2： Lighting This interface uses a color palette or RGBW to color all the lamps, as shown in the following figure:
PAGE 5
4、 PAGE3：Color Click on the lamplight in the graph to control the color of each lamplight individually. Add new color: Click the button “ button“ ”.
PAGE 6
5 、PAGE4：Timer Click the Add button “ ”. Select the number of repetitions once or every week or every day. Select the start time, the end time, the scene.
PAGE 7
Installation Instruction Model: Rating: N002D4-S-K01-15 30W Max 15PCS 120V Max Parallel Qty Power Max Input Current 15 30W 0.45A 30 60W 0.83A 60Hz N002D4-S-K01-30 60W Max 30PCS 120V 60Hz Spec Important Safety Instructions: Type (Wall Mounting By Installation Accessories)： Accessories List: Step1： According to the shape of splicing, fix the accessories on the required wall position by screws.
PAGE 8
Step2： Pull the switch on the side of the light panels and pull out the connector to the clamp position. Step3： Splice and fix the light panels on the accessories.
PAGE 9
Step4： Connect controller.
PAGE 10
Step5： Connect the driver and plug in the power plug and start using.
PAGE 11
FCC WARNING Any Changes expressly or modifications not approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.