Instructions

ManualsBrandsAnsmann ManualsBattery ChargersAnsmann Comfort Smart NiMH AAA , AA Charger for cylindrical cells

13 12

§Do not attempt to charge non-re-

chargeable batteries.

§Always place the product on a flat,

stable and heat-resistant surface.

§Do not use the product near flam-

mable liquids or gases.

§Make sure that the ventilation slots

on the bottom housing of the char-

ger are not covered.

§Do not leave the product unatten-

ded during use.

Only use the product in dry

indoor areas and protect it from

moisture.

PRODUCT DESCRIPTION (SEE PAGE 2)

A: Charging compartment

B: Opening to allow for the easy removal of the batteries

C: Multi-colored LED display (red, orange, green)

D: USB power supply connector

OVERVIEW OF FUNCTIONS

Quick charger with USB input for 1-4 NiMH batteries of the sizes Micro

AAA / Mignon AA incl. USB cable

Microprocessor controlled charging with single cell monitoring

Automatic start of charging and charging current adjustment after

insertion of the batteries with correct polarity

Status indication via 3-colour LED per charging slot

Intelligent "PERFECT 7 CHARGING" function (SEE PAGE 2):

Italiano | Nederlands | Dansk | Suomi | Norsk

Italiano | Nederlands | Dansk | Suomi | Norsk

1. Capacity quick test: Residual capacity is determined

before charging begins and displayed for 5 seconds

2. Gentle pre-charging: Weak or deeply discharged battery is

pre-charged with lower current if necessary

3. Battery analysis: Battery behavior is analyzed and

evaluated to determine whether it is still reliably usable or

defective

4. Quick charge: Battery is charged at maximum current

5. IQ switch-off: Intelligent monitoring of the battery for

reliable charging and multiple protection against overcharging

6. Top-off charge: Ensures that the battery is gently charged

to 100% capacity

7. Trickle charge: Battery is kept in a fully charged state by

means of charging pulses

OPERATION

§ Connect the charger with the included USB cable.

§ Connect the USB cable to any suitable USB port (e.g. power

supply, PC, Power bank…).

§ Insert the battery into the charging slot with the correct polarity

(see engraving in the charging slot).

§ The product displays the charge status of the battery for 5 seconds

and then automatically starts the charging process.

§ As soon as a battery is fully charged, the charger switch to trickle

charge.

§ You can now remove the fully charged battery.

§ After all batteries have been removed, disconnect the product from

the power supply

LED INDICATION

Red Orange Green

Capacity indication (for the first 5s

after insertion)

<25% 25-75% >75%

Charging On

Error Flashing

Full / trickle charge On

Pause (*1) Flashing