Instructions

7
Deutsch | English | Français | Español | Português
Svenska | Italiano | Nederlands | Suomi | Norsk | Dansk
PRODUCT DESCRIPTION
1 Carry handle
2 Adjusting screws
3 Rechargeable battery
capacity indicator
4 On/off button
5 Protective rubber coating
6 Charge socket
7 Base
HANDLING NOTES
• Always carry the product using the handle.
• Always set the product down on its stand.
• Always hang the product with the hanging eye.
• The joint has a resistance in order to prevent unintentional
adjustment. Change the angle of the stand slowly and
smoothly.
ADJUSTING THE SPOTLIGHT
• Loosen the two locking screws.
• Adjust the angle of the spotlight.
• Tighten the locking screws again.
FIRST USE
The on/off button is on the back of the housing.
Press 1x: 25%
Press 2x: 50%
Press 3x: 100%
Press 4x: Off
CHARGING
Before first use, charge the lamp fully with the mains adapter
provided. Likewise, when storing over an extended period of
time, charge beforehand and charge at least 1x per year during
storage in order to prevent the rechargeable battery pack deep-
discharging.
To do so, pull the sealing cap out of the charge socket on the
rear of the housing and plug in the charge plug. Then plug
the mains adapter into the mains outlet. Ensure that the site
floodlight is not lying with the light-emitting side downwards.
LED RECHARGEABLE BATTERY INDICATOR
ON THE REAR OF THE HOUSING VIA
STATUS LEDS
Charge status:
The illuminated indicator LEDs show the charge status.
The charging process is indicated by an LED flashing.
Remaining capacity indication:
The number of illuminated indicator LEDs indicates the remaining
battery capacity.
SIMULTANEOUS CHARGING AND LIGHTING
The light can be used whilst it is charging. In doing so, please
note that the lighting power is reduced when the mains adapter
is connected, in order to protect the rechargeable battery from
damage.
Note that the charge time is also significantly increased by this.
The lamp shall be set down only on stable and non-slip surfaces
that are as close to horizontal as possible. When placing it on
slight inclines ensure that the feet are arranged such that the
lamp cannot topple over face-down, onto its light-emitting side.
HOLDING DEVICES (STANDS, MAGNETS,
ETC.)
If the light is to be fastened with a holding device, ensure that
the holding device is firmly/properly fastened in place in order to
avoid possible damage due to the light falling.
CLEANING/MAINTENANCE
Carry out cleaning tasks only when the mains plug is removed
from the mains power!
• Clean only with a slightly damp cloth, then rub it dry.
• Never submerge the product in water or other liquids.
• Do not allow fluids to enter the housing.
• Do not use hard brushes or sharp objects for cleaning.
Improper usage of the lamp may result in it being damaged:
• Do not throw or drop
• Use only in original condition
• Do not use while still in packaging
• Turn off after use
TECHNICAL DATA FOR LAMP
Model
1600-0274:
FL800R
1600-0275:
FL1600R
1600-0276:
FL2400R
Power in Watts 10 W 20 W 30 W
Li-ion
rechargeable
battery pack
7.4V
2200mAh
16.28Wh
7.4V
4400mAh
32.6Wh
11.1V
4400mAh
48.9Wh
Input voltage 12V DC 12V DC 13.5V
Input current 500mA 1000mA 1000mA
IP protection class IP54 (splash-protected)
IK protection class IK05
Protection class III
Illuminant type SMD-LED
Colour
temperature
5000 K
Colour rendering index (CRI) >80 Ra
Nominal luminous
flux
100%: 800 lm
50%: 400 lm
25%: 200 lm
100%: 1600 lm
50%: 800 lm
25%: 400 lm
100%: 2400
lm
50%: 1200 lm
25%: 600 lm
Battery life
100%: 3h
50%: 6h
25%: 12h
100%: 3h
50%: 6h
25%: 10h
100%: 3h
50%: 6h
25%: 10h
Charge time 4h 4-5h 5-6h
Max. projection
area
474 cm
2
726 cm
2
797 cm
2