User manual

> The device is not to be used by children or persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they are given
supervision or specific instructions!
> Do not leave the device unattended when in operation!
> Disconnect the charger from mains supply after use!
> If the safety instructions are not followed, it may lead to damage to the charger or battery and could cause injury!
> We recommend the use of ANSMANN rechargeable batteries!
FUNCTIONAL OVERVIEW
> Intelligent charger for 1 - 4 NiMH or NiCd rechargeable cells in sizes Micro (AAA), Mignon (AA), Baby (C), Mono (D) plus one 9V Block (E)
> Charging status indicator via LED
> Individual charging of each cell position
> Reverse polarity protection
> World wide use (100-240V AC / 50-60Hz)
For round cells:
> Capacity quick test for approx. 5 seconds after inserting the cells
> Microprocessor controlled charging
> Automatic charging current adjustment
> Multiple over-charging protection
> Trickle charging
> Faulty cell detection / accidental Alkaline insertion detection
OPERATION
Connect the charger to the mains power (100-240V AC / 50 - 60Hz).
1. Charging of round cells: 1 - 4 NiMH or NiCd rechargeable batteries of the sizes Micro (AAA), Mignon (AA), Baby (C) or Mono (D) can be charged. To insert round cells slide
the contact bridge backwards and put in the rechargeable battery at the bottom of the charging slot. Always connect the cells in the right direction for polarity according to
the symbols in the charging slot. Immediately after inserting a cell, the charger measures its capacity and indicates the result for approx. 5 seconds via the LED next to the
specific charging slot (see CAPACITY QUICK TEST FOR ROUND CELLS). Then the charging procedure starts automatically. The charge condition of the cells before charging is
irrelevant. The charge status of each cell will be indicated on the respective LED above each charging slot (see CHARGING STATUS INDICATOR FOR ROUND CELLS). The cells do
not have to be inserted simultaneously as the charging processes are independent from each other. It is normal that cells become warm during charging. After charging is
completed, the charger switches automatically to trickle charge.
2. Charging of 9V battery: One 9V Block (E) can be charged when no Mono (D) batteries are inserted on the left or right side of the 9V charging slot. Ensure that you insert
the 9V battery in the correct direction for polarity according to the symbols in the charging slot. The indicator (LED) above the 9V charging slot lights red when the battery
is inserted correctly. Please only charge discharged batteries to avoid over charging the 9V battery. Please take a look to the charging times per 100mAh in table [1] and
remove the 9V battery from the charging slot after the correct charging time.
CAPACITY QUICK TEST FOR ROUND CELLS (indication for approx. 5 seconds)
LED green lights: battery is nearly fully charged, so charging is not necessary
LED green blinking: battery has some reasonable capacity, but charging still recommended
LED red lights: battery has little capacity, so charging is required