User Manual

Antelope Audio Zen Go Synergy Core User Manual
Page 25
Control Menu
Press and hold 'Gain' to enter the Control Menu. Turn the rotary control to navigate the
menu and select an entry. Press the rotary control to enter the sub-menu for the entry.
Turn the rotary control to browse the available choices and make adjustments. Press the
rotary control to confirm.
T
he Control Menu has the following entries:
● Power OFF - press the rotary control to enter standby. Press again to wake th
e
d
evice.
● Clock Source - choose the clock source (Internal, S/PDIF, USB or USBCC*). Note
that in USB mode, the unit still syncs to its internal clock.
*USB Class Compliant – when set on this clock source the device will work with
Android/Linux-based systems without drivers.
● Sample Rate - choose the device sample rate (32kHz - 192kHz). Make sure your
choice always matches the DAW and operating system sample rates.
● Monitor Trim - choose an audio signal trim value for the monitor outputs (14dBu -
20dBu). By default, this option is set to 20dBu. Trim can be used to compensate
for the perceived volume differences between two or more sets of speakers so that
they produce the same perceived volume level.
● Line Out Trim - choose an audio signal trim value for the RCA outputs (14dBu -
20dBu). By default, this option is set to 20dBu. Trim can be used to compensate
for the perceived volume differences between two or more sets of speakers so that
they produce the same perceived volume level.
● Brightness - adjust screen brightness (5% - 100%).
Pr
ess the 'Antelope button' to exit the Control Menu.