User Manual

Antelope Audio Zen Go Synergy Core User Manual
Page 35
Monitor incoming microphone audio via headphones
Say you want to monitor incoming microphone audio from input A1 via Headphone output 1
(HP1). Connect your equipment and open the Control Panel. Do the following:
1
.
I
n the 'PREAMPS' section, head to the leftmost preamp and click on the signal type selector
drop-down menu. Choose 'Mic' and don't forget to activate 48V phantom power if your
microphone requires it.
2
. C
lick the input selector above the 'AFX' area and choose PREAMPS > PREAMP 1 from the
menu.
3.
A
djust input gain until you hear the microphone audio in your headphones.
Apply Synergy Core FX to incoming audio
Click the 'AFX' area below the input selector to open the Synergy Core FX rack window. Click
the 'ADD NEW EFFECT' button and make your choices. Close the window when you are done.
Play guitar through the virtual amps and cabinets, listening from studio monitors
1. Connect your guitar to input A1 and your monitors to the interface's monitor outputs.
2. Open the Control Panel and head to the leftmost area in the 'PREAMPS' row. Choose 'Hi-Z'
f
rom the signal type selector drop-down menu.
3.
Cl
ick the input selector above the 'AFX' area and choose PREAMPS > PREAMP 1 from the
menu.
4.
Cl
ick the 'AFX' area below the input selector to open the Synergy Core FX Rack. Click 'ADD
NEW EFFECT' and make your guitar amp and cabinet choices from the menu. If you don't
know where to start, the 'Modern (US)' amp and 'Modern 4 x 12' cabinet combination make for
a great modern rock/metal rig.
Sing with microphone emulations and monitor live with headphones
1. Connect your headphones to input HP1 on the front panel.
2. Connect your Antelope Audio Edge or Verge modeling microphone to inputs A1 and/or A2
on the rear panel. In this example, we are using the Edge Solo, which is connected to input A1.
3.
O
pen the Control Panel and head to the leftmost preamp from the PREAMPS row. Click the
input selector above the 'AFX' area and choose PREAMPS > PREAMP 1 from the menu.
4. Click on the mic emulations button to open the mic emulations window. Choose Edge
Solo with the dial.
5. Adjust microphone gain with the gain knobs. You should be hearing mic audio in your
headphones at this point.