Installation Guide

ANTICO ELEMENTS - Headquarters: 3520 NW 46Th Street Unit #4 33142 Miami, Florida United States
Touch-up where necessary using the same paint used for the last coat.
When installing multiple rows of panels we strongly recommend starting the odd rows with half panel. See image below.
It is now time to install the mitered pieces. Apply the construction adhesive on the inside of one of the edges, or both. Secure the
two pieces over the substrate with a finish nailer or screws
TIP: Apply enough adhesive so that it will squeeze out and fill all the gaps. Let the excess adhesive dry overnight before cleaning
it up. The day after you can easily remove the excess with a utility knife and fill all the gaps. If cleaning the adhesive while wet you
will notice that as it dries it shrinks leaving a visible line, which will require more caulking.
After the adhesive has been removed use a sanding block or sand paper to smooth out and lightly round the very edge of the
corner and help the two sides blend with each other. Remove all dust and apply the caulking on the corner and screw heads.
Thank you for Using Antico Elements' Faux Brick Products. Please do not hesitate to contact us with any question.
Installation Instructions forTBBR-2745 White Brick Panel
Page 4