Instructions / Assembly

Trouble Shooting

1. Fan doesn't work

• Make sure the fixture is connected to an ON/OFF wall switch, not dimmer switch.

• Check the remote control battery (not included in this package).

• Check the circuit breaker to ensure the power is on.

• Turn off power from the circuit breaker, then loosen the canopy and check all the

connections according to the wiring diagram.

2. Bulbs Do Not Light Up / Flicker / Noisy Operation

• Make sure the fixture is connected to an ON/OFF wall switch, not dimmer switch.

• Check your power and switch to make sure it's power on.

• Check the bulb to make sure it's installed correctly.

• Change a new bulb.

3. Noisy Operation

• Tighten the light ﬁtting

• Re-tighten all screws on bracket, downrod (do not over tighten).

• Check to see if any of the blades are cracked. If so, replace the blades.

4. Excessive wobbling

• Tighten all of the screws.

• Check that the hanger ball is properly seated. Be sure the fixation slot is locked

by the bracket (Fig 5).

5. Remote does not work

• Make sure the battery is installed correctly.

• Pair the remote control again (See page 8).

• Install 2 new batteries.