Instructions / Assembly

1. Be sure the power to the wires you are working on is disconnected, either the fuse
is removed or the circuit breaker is turned off. Turning the power off using the light
switch is not sufficient to prevent electrical shock.
2. A qualified licensed electrician is required for the installation.
3. The outlet box and support structure must be securely mounted and capable of reli-
ably /supporting a minimum of 50 pounds. Use only UL (cUL for Canadian Installation)
listed mounting boxes marked "FOR FAN SUPPORT".
4. The fan must be mounted with a minimum of 7 feet clearance from the trailing edge
of the blades to the floor.
5. Do not operate reversing switch while fan blades are in motion (if applicable). Fan
must be turned off and blades stopped before reversing blade direction.
6. Do not place any objects in the path of the blades.
7. To avoid personal injury or damage to the fan and other items, be cautious when
working around or cleaning the fan.
8. Do not use water or detergents when cleaning the fan or fan blades. A dry dust cloth
or lightly dampened soft cloth will be suitable for the cleaning.
9. After marking electrical connections, spliced conductors should be turned upward
and pushed carefully up into outlet box. The wires should be spread apart with the
grounded conductor on one side of the outlet box.
10. Electrical diagrams are reference only, different fan light may have different light
shade and bulbs.
11. Use only our replacement parts. This equipment has been tested and found to
comply with the limits for a class B digital device, pursuant to part 15 of the FCC
Rules. These limits are to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio fre-
quency energy and if not installed and used in accordance with the instructions may
cause harmful interference to radio communications.
Warning:
To reduce the risk of personal injury, use only the two steel screws and washers pro-
vided with the outlet box for mounting to the outlet box. Most outlet boxes commonly
used for the support of lighting fixtures are not acceptable for fan support and need to
be replaced, consult a qualified electrician if in doubt.
To reduce the risk of fire, electric shock or person injury, mount fan to outlet box
marked "acceptable for fan support".
To reduce the risk of personal injury, do not bend the blade brackets (also referred to
as flanges) during assembly or after installation. Do not insert objects in the path of the
blades.
Safety Rules
3 Email: [e-mail]