Instructions / Assembly
3. Wiring
Outlet box
Mounting
bracket
Canopy
Screw Screw
Step 1. Insert the wires and wire connec-
tors into the outlet box.
Step 2. Slide the canopy upto the ceiling
and attach it to the mounting bracket with
the screws provided. Tighten all screws
securely.
Fig. 9
Step 1. Insert the remote receiver to the
bracket as figure 8.
Step 2. Connect the receiver black wire
to your house live wire, white wire to your
neutral wire, yellow/green wire from the
downrod to your ground wire.
Step 3. Connect the three wires from the
receiver to the fan wires, black to black,
white to white, red/blue to blue.
Step 4. After connecting the wires,
spread them apart so that the live wires
are on one side of the outlet box and the
neutral wires are on the other side.
Fig. 8
4. Attaching the Canopy
Fig. 9
NOTE: THIS FAN ONLY NEEDS ONE
SET OF INPUT WIRES (black, white
and ground wire). Both of the fan and
lights will be controlled by the remote
controller. The wall switch is not able to
control the fixture full functionally.
THIS FAN CAN ONLY BE
CONNECTED ONTO ON/OFF SWITCH
IF YOU HAVE ONE, NOT SUITABLE
FOR DIMMAER SWITCH.
Email: homechandelier@qq.com 6