Instructions / Assembly

Trouble Shooting
1. Fan doesn't work
• Press a fan speed button (1-3).
• Check the remote control battery (not included in this package).
• Check the circuit breaker to ensure the power is turned on.
• Make sure the blades spin freely.
• Turn off power from the circuit breaker, then loosen the canopy and check all the
connections according to the wiring diagram.
2. LED panel doesn't light up
• Check the wire connectors to see if all of them are connected correctly.
• Check the circuit adapter to see if it's inserted in the ending slot of the LED panels.
3. LED light doesn't turn off
• Adjust the LED panels, no touching with the LED driver, the frame and the fan base
except for the magnets.
• If above step doesn't help, please use the insulation tape to cover each magnet of
the LED panels and LED driver, then attach the panels and driver as above step.
4. Noisy Operation
• Tighten the light fitting
• Re-tighten all screws on bracket, downrod and fan blades (do not over tighten)
• Check to see if any of the blades are cracked. If so, replace all of the blades.
5. Remote does not work
• Make sure the battery is installed correctly.
• Install 2 new batteries.
6. Excessive wobbling
• Tighten all of the blade screws until they are
snug.
• Turn the power off, support the fan carefully,
and check that the hanger ball is properly
seated.
• Use the provided balancing kit and instruc-
tions to balance the fan:
Step 1. Attach the magnet to place①, ②, ③ or
④, turn on the fan and test where it needs the
balance kit.
Step 2. Replace the magnet with the balance
paster.
Balance paster
Magnet
Email: [e-mail] 12