Installation Guide

2
a)
b)
Touch the button for LED light and anti-fog control;
Long press button for dimming. It will change the LED brightness from 10%-100%.
MAINTENANCE
INSTALLATION INSTRUCTIONS
Apply to the below style of LED Backlit Mirror
Please read carefully and save these instructions.
Don’t discard any of the packaging until you are sure that you have all of the parts and the fittings.
Make sure power to the junction box is off before commencing installation.
IMPORTANT

Unpack mirror. DO NOT lay mirror on tiled or concrete surface prior to installation.
Mirror must be on protected surface to prevent chipping of the corners.
 Care must be taken before drilling pilot holes to avoid any existing wiring or pipe work that may
be concealed.

A certified electrician must perform all work. The mirror must be connected to a GFI.

The anti-fog mat operates only when the LED light is turn on by the touch sensor.
INSTALLATION
Please refer the installation diagram on the back of the page.
1) Unpack the LED mirror and prepare tools needed.( See Pic.1 )
2) Make sure the measurement on the carboard screw holes are matching up with aluminum base on
the mirror back, then mark the screw holes according from the carboard with pencil.(See Pic.2)
3) Drill holes, and put in the plastic plugs, then fix the aluminum bar by screws and twisting
the T shape nail to the wall.(See Pic.3&Pic.4);
4) Connect hardwire to power line.(Make sure the power off) (See Pic.5)
5) Hanging the LED mirror with aluminum bar and lock it with the anti-pull iron sheet by using the
spanner provided at the fittings bag.(See Pic.5&Pic.6)
Wipe clean with a soft damp cloth. Apply glass cleaner to cloth and do not apply directly to mirror.
Never use abrasive cleaners as these could damage the finish or exposed LED strips.
FUNCTION DESCRIPTION
Touch sensor switch: Turn the light and anti-fog function by the dimmable sensor switch, see details
as below:
Button: