Installation Guide

Step 1 Faucet and pop-up installation
3
2
1
2
2.Check all connections at arrows for leaks, re-tighten it if necessary.
BUT DON'T OVERTIGHTEN
Step 3 Cleaning and care
Daily cleaning and care are required in order to keep the product shining and
properly working.
1
2
3
4
Clean it with water and dry it with soft cloth.
Clean the product with gentle liquid or glass cleaner.
Don't use acid cleaner.
Don't clean with abrasive material, abrasive paper or knife.
1
1.Remove pop-up drain stopper, and flange with top rubber washer for pop-up assembly. Insert drain body from
underneath of sink drain hole. Replace flange and top rubber washer back to drain body. Tighten flange as far as
possible. Remove and put silicone along bottom of. (Optional) Slide bottom rubber washer on drain body up against
bottom of sink. Tighten washer and locknut firmly against base for tight seal. Remove tailpiece from drain body, add
Teflon tape, replace tailpiece.
2.Replace pop-up drain stopper to drain body with o-ring in place, and align stopper hole with guide rod opening.
3.Remove rod guide nut and rod ball plastic gasket. Insert horizontal rod into drain body and through hole in drain
stopper. Replace rod guide nut with rod ball plastic gasket and tighten it.
Step 2 Checking and testing
4.Insert lift rod through hole on faucet body. Connect extend rod to lift rod. Attach horizontal rod to extend rod using
fittings, tighten screw.
Faucet installation
rod guide nut rod ball
plastic
gasket
drain
stopper
hole
drain body
o-ring
sink
drain stopper
flange
align hole in
drain stopper
with guide rod
opening
(pointed toward
back wall)
flange
drain body
top rubber washer
sink base
locknut
washer
bottom
rubber
washer
tailpiece
horizontal rod
drain body
1
2
3 4
Pop-up installation
HOT
COLD
1/2”( 13mm)IPS
WARNING:
DON'T OVERTIGHTEN!
4
1.Position the body with o-ring in the installation surface as shown and secure it with gasket assembly and tighten
the lock nut with adjustable wrench.
2.Position the handle in installation surface as shown and secure it with fixing kit and tighten the screw with
screwdriver. Repeat the above steps for the other handle.
Caution: please be caution with the position of hot and cold handles.
3.Position the as shown and fix it to the faucet as shown with .flexible hose clamp spring
Warning: The water supply valve mentioned above are not included, please purchase them from plumbshop.
4.Connect the water supply lines to faucet and water supply valve and tighten it with wrench.
1.
water lines for one minute. Reinstall aerator by hand.
Remove the aerator by hand. Turn the faucet handle all the way on, turn on hot and cold water supply and flush
lift rod
faucet
body
extend rod
horizontal rod
screw
fittings