ee a AD VVA Instruction Manual ® REA DESIGN, x EFFICIENCY AGING CERTIFIED ina GAIA certification apples to all residential gas water heaters with capacities of 20 to 100 galls with input rating “of 75,000 BTU Mr. or less. SERFS, NOT FOR USE IN MANUFACTURED (MOBILE) HOMES WARMING: If the information in these instructions is not followed exactly, a fire or explosion may result causing property damage, personal injury or death.
aly ANL E a a Your safety and the safety of others is extremely important in the installation, use and servicing of this water healer, Many safety-related messages and instructions have been provided in this manual and on your own water heater to warn you and others of a potential injury hazard, Read and bey all safety messages and instructions throughout this manual, if is very important that the meaning of each safety message Is understood by you and others who install, use or service this water heater, T
PE 3 BA WARNING Read and understand instruction manual and safety messages before installing, operating or servicing this water heater, Failure to follow instructions and safety messages could result in death or serious injury. Instruction manual must remain with water heater, WARNING # Fire Hazard For continued protection against risk office; Do not install water heater on carpeted floor.
» BE a SAFE INSTALLATION, USE AND SERVICE coves 2 GENERAL SAFETY | TABLE OF CONTENT! INTRODUCTION... rr Preparing for the New Installation TYPICAL INSTALLATION ooh LOCATING THE NEW WATER HEATER | Facts to Consider About Location . Ingratiation Blankets coi 8 Combustion Air and Ventilation for Appliances Located in Unconfined Spaces...
GET TO KNOW YOUR WATER HEATER GAS MODELS Vent Pipe Draft hood Anode Hot Water Outlet Outlet insulation Gas Supply —Tomato mE Ground Joint Union * INSTALL IN ACCORDANCE WITH LOCAL CODES, * DRIP LEG AS REQUIRED BY LOCAL CODES. TO VENT TERMINATION ON ROOF z TALL PIPING MATERIALS TO BE SUPPLIED BY CUSTOMERS.
Se MIXING VALVE USAGE HOT WATER OUTLET TEMPERED TEMPERED WATER caf CUTLET HIEING VALVE BAS SUPPLY) DRAIN PAN VACUITY RELIEF REQUIRED BY SOME CODES Protrusions. RELIEF VALVE {REFER TO LOCAL CODES) LET TEMPERED COLD RETURN TEMPERATURE-PRESSURE DISCHARGE PIPE {00 NOT CAP OR PLUG) CERTAIN MODELS ARE EQUIPPED WITH SIDE PLUMBING CONNECTIONS FOR SPACE HEATING. THE HOT AND COLD FITTING ASSEMBLIES (PART #9681282) CAN BE ORDERED THROUGH THE MANUFACTURER FIGURE.
ANEW FACTS TO CONSIDER ABOUT THE LOCATION Carefully choose an indoor location for the new water heater, because the placement is a very important consideration for the safety of the occupants in the bulling and for the ost economical use of the appliance. This water heater is not for use in manufactured {mobile} homes or outdoor installation. Whether replacing an old water heater or ping the water heater ina new location, the following critical points must be observed 1.
TOP VIEW TOP VIEW OF CLOSET OF CLOSET WITHOUT DOOR WITH DOOR BY 0 nam. 0" HAN wn. TTYS mim) 0" MIN, bi HIN FIGURE 3, A gas water heater cannot operate proper without the correct amount of air for combustion. Do not install in a confined area such as a closet, unless you provide air as shown in fhe “Locating The New Water Heater" season. Never obstruct the flow of ventilation air. If you have any doubts or questions at al, call your gas supplier.
unconfined space. The total input of all gas utilization equipment installed in the combined space shall be considered in making this determination. Each opening shall have a minimum free area of one square inch per 1,000 Blu per hour (22 emi) of the total input rating of all gas utilization equipment in the confined space, but not less than 100 square inches (B45 cm?) One opening shall commence within 12 inches {30 am) of the top and one commencing within 12 inches (30 em) of the bottom of the enclosures.
WATER PIPING Water temperature over 125°F (82°C) can cause severe burns instantly resulting in severe injury or death Children, the elderly, and the physically or mentally disabled are at highest risk for scald injury. Feel water before hating or showering. Temperature limiting valves are available, ADAGE Read instruction manual for safe temperature setting HOTTER WATER CAN SCALD: Water heaters are intended to produce hot water.
Figure 8 shows the typical attachment of the water piping to the water The valve must be marked with a maximum set pressure not to exceed heater, The water heater is equipped with 3/4 inch NPT water the marked hydro static working pressure of the water heater connections (150 psi = 1,035 kPa} and a discharge capacity not less than the water heater input rate as shown on the model rating plats.
Gina SHUT-OFF VALVE FH Fr GOLD TEMPERATURE & PRESSURE RELIEF VALVE {OPTIONAL TOP TAP DRAFT HOOD RELIEF VALVE SHOWN) DRAIN VALVE Pe DISCHARGE PIPE (DO NOT CAP OR PLUG) FIGURE 10. FILLING THE WATER HEATER CAUTION Property Damage Hazard * Av old water heater damage. « Fill tank with water before operating. Never use this water heartiness iris completely full of water. To prevent damage to the tank, the tank must be filled with water.
There must be a minimum of 6 inches (153 mm) clearance between single wall vent pipe and any combustible material. Fill and seal any clearance between single wall vent pipe and combustible material with tartar mix, cement, of other noncombustible substance. For other than single wall, follow vent pipe manufacturer's clearance specifications.
Use pipe joint compound or Teflon taps marked as being resistant to the action of petroleum [Propane (LP) gases. The appliance and its gas connection must be leak tested before placing the appliance in operation The appliance and its individual Shut-off valve shall bs disconnected from the gas supply piping system during any pressure testing of that system at test pressures in excess of 1/2 pound per square inch (3.5 kappa.
FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: 1 you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of fife. FLAMMABLE BEFORE OPERATING: ENTIRE SYSTEM MUST BE FILLED WITH WATER AND AIR PURGED FROM ALL LINES. A. This appliance has a plot which is lit by a pie-electric spark gas ignition system. Do not open the inner door of the appliance and fry to light the pilot by hand. 8. BEFORE LIGHTING smell alt around the appliance area for gas.
= = fain Due fo the nature of the typical gas water heater, the water temperature in certain situations may vary up fo 30F° (18.7 C°) higher or lower at the point of use such as. bathtubs, showers. sink. eto, Water temperature over 128°F (82°C) can cause severe burns instantly resulting in severe injury or death Children, the elderly, and ihe physically or mentally disabled are at highest risk for scald injury. Feel water before bathing or showering.
Because of the suddenness and amount of water, condensation water ray be diagnosed as a “tank Sakai. After the water in the tank warns up (about 1-2 hours). the condition should disappear. Do not assume the water heater is leaking unt thees has been enough time for the warts in the tank to wan up. An undersized water heater will cause more condensation. The water heater must be sized properly to meet the family's demands for hot water including dishwashers, washing machines and shower heads.
IY] bn ik VENTING SYSTEM INSPECTION BATE Breathing Hazard Carbon Monoxide Gas * Lug gases may escape if vent pipe is not connected. « Be alert for destructed, suited or deteriorated vent system to avoid serious injury or death. + Do not store corrosive chemicals in vicinity of water heater. » Chemical corrosion of flue and vent system can cause serious injury or death, Breathing carbon monoxide can cause brain damage of death Always read and understand instruction manual.
INSTALLED IN SUITABLE AREA: To insure sufficient ventilation and combustion air supply. proper clearances from the water heater must be maintained. See "Locating the New Water Hater” section Combustible materials such as clothing, dealing materials, or flammable liquids, eto. must not be placed against or adjacent to the water heater which can cause a fire ANODE ROD INSPECTION CAUTION Property Damage Hazard » Avoid water heater damage « Inspection and replacement of anode rod required.
& Follow the lighting instructions in the “Lighting” section fo restart the water heater. Pt HANDLE AND 8 CAP ASSEMBLY WASHER FIGURE 18. SERVICE 1f a condition persists of you ars Uncertain about the operation of the water heater contact a service agency. Use this guide to check a “Leaking” water heater. Many suspected “Beakers” are not leaking tanks. Often the source of the water can be found and forested. if you are not thoroughly familiar with gas codes.
HED Key No.
2e@180= HOO FIN B xv These guidelines should be utilized by a qualified service agent. When calling for service notify the service agent that this is a *Flammable Vapor ignition Resistant Product, Problem (ell Solution Improperly sealed, hot or cold supply connection, | Tighten threaded connections. WATER LEAKS relief valve, drain valve. or thermostat threads. Leakage from ihe appliances of wale lines. Inspect haler appliances near wale heater, Condensation of flue products, Deter to CONDENSATE.