Instructions
8
2. Scope of delivery
• 1x Battery charger • 1 x Operating instructions
• 4 x Cable holders
3. Specications
Dimensions: 145 x 90 x 170 [mm] Weight: 1.710 kg
Long of mains cable: 1.70 m
Long charger cable: 1.40 m
Input: 220-240 V AC 50/60 Hz Output: 12 V mode: 4 V, (6 A RMS), DC
Battery capacity: 20 – 110 Ah
Ambient temperature: -5 °C to +40 °C
4. Safety precautions
• Keep children away and do not allow children to operate this device!
• Only use this product as intended!
• Do not manipulate or disassemble the device!
• For your own safety, only use accessories and spare parts that are stated in these instructions or that are
recommended by the manufacturer!
• The warning triangle labels all instructions important to safety. Always follow these otherwise you could
injure yourself or damage the device.
• Do not smoke and do not ignite naked ames when working on the battery. There is a risk of explosion.
• Only connect the device to a power socket installed according to regulations. The voltage must correspond
to the specication on the type plate of the device.
• Do not trap the power cable and protect it from sharp edges, damp, heat or oil. The power cable of the unit
cannot be replaced. In the event that the cable is damaged, the unit must be disposed of.
• Do not operate the device or immediately pull the plug if it is damaged or you suspect it may be defective.
In this case, contact our technicians.
• Pull the plug when the device is not in use.
• Keep packaging materials, especially plastic and plastic bags, away from children. Risk of suocation.
• Remove all plastic from the device before use.
• Place the mains cable in such a manner that it does not impede and that it cannot be unplugged
accidentally.
• Disconnect the battery charger from the power supply after the charging process.
• Keep the charger in a place that cannot be accessed by children or unauthorised persons.
• Never operate the device in the vicinity of ammable materials or in an environment prone to explosion.
• Always wear suitable working clothes, protective gloves and goggles. Battery acid is corrosive!
Immediately and thoroughly wash o any splashed acid and consult a doctor, if necessary. If battery acid
gets into the eyes, immediately rinse under running water for at least 10 minutes and consult a doctor.
• Do not cover the charger, this may lead to overheating and result in damages. Never set the charger up for
operation on a surface that is insulating (e.g. polystyrene). There is a risk of heat built up!
• If you wish to charge a vehicle battery in the installed state, rst park the vehicle safely, put on the parking
break and switch o the ignition. Cut the battery o from the on-board network of your vehicle. To do this,
consult the manual for your vehicle, or ask your specialist workshop.
• This charger enables you to charge a battery without needing to disconnect it from the on-board network.
If you wish to make use of this option, make sure that your vehicle will not be damaged by this process. For
this purpose, read the manual of your vehicle or ask your specialist workshop.