Product Datasheet/Brochure

4
Back-UPS BVN650M1, BVN650M1-CA, BVN900M1, BVN900M1-CA
Turn On the Back-UPS
Press the POWER button. It will illuminate green and a single short beep indicating that the
Back-UPS is on and providing protection for connected equipment. The Back-UPS battery
will charge regardless of whether the Back-UPS is switched on or off as long as it is
connected to AC power. The UPS will have full runtime capability after the initial 24-hour
charging period, connected to AC power.
If the red Building Wiring Fault indicator (located on the end near the power cord) is lit, your
building wiring may present a shock hazard that should be corrected by a qualified
electrician.
Quick Mute
The Back-UPS is able to temporarily mute user correctable alarms such as On Battery.
During such alarms, a short press (less than 2 seconds) of the POWER button will
temporarily mute the alarm until the condition has been reset. A short double beep will
confirm that Quick Mute has been activated. Pressing the POWER button for more than 2
seconds will turn off the UPS.
Other critical events such as Battery replacement and Charger notification can not be
temporarily muted. The unit in these cases must be turned off.
On Battery Indicator Modes
With the UPS turned on, configuring the On Battery Indicator modes below is done by
holding down the POWER button and waiting for the third beep. At the third beep, the
POWER button will cycle red / green. Release the POWER button and its color will
indicate the mode the UPS is in. Press the POWER button to cycle through each mode.
See the following table for the 3 mode selection colors. Once the mode has been selected,
wait 5 seconds and the setting will be committed to the UPS.
Mode
Visual
Indicator
Audible Indicator
Mode Selection
Color
Quiet Alarm
(default)
The POWER
button is solid
green and flashes
twice every 2
seconds until Low
Battery
notification where
it will flash green
in rapid
succession.
No alarm until Low Battery
notification where the alarm beeps
twice every 30 seconds
Flashing green
No Alarm
No alarm while the UPS is On
Battery
Flashing red
Full Alarm
Alarm sounds 4 beeps every 30
seconds until Low Battery
notification where the alarm beeps
every half second. As the UPS shuts
down, it sounds one beep every 4
seconds
Flashing amber