Owners manual

- 5 -
Front Panel Controls and Indicators
The front panel controls and indicators for the H15 Power Conditioner are
detailed in Figure 2. Each numbered callout refers to the numbered descrip-
tion found immediately below the picture.
Figure 2. H15 Front Panel Controls and Indicators
Wiring OK Status Indicator
When lit, the receptacle into which the H15 is plugged is prop-
erly wired. If not lit, one of three wiring problems exists in the
building wiring circuit: missing ground, overloaded neutral, or
reversed polarity. An electrician should be consulted to resolve
the problem.
Line OK Status Indicator
When lit, input voltage from the utility is within acceptable
range. If not lit, input voltage from the utility is too far out of
the acceptable range for the H10 and it will go into boost or trim
mode to compensate for the low or high incoming line voltage.
Filtering Status Indicator
When lit, notifies the user that the EMI/RFI noise reduction cir-
cuit is active.
Line Boost Status Indicator
When lit, Automatic Voltage Regulation (AVR) is engaged to
correct low input voltage conditions.
Switched On Status Indicator
When lit, the power is on at all outlets except those with a pro-
grammed delay.
4 5 621 3
12 11
10
9
8
7
1
2
3
4
5