Owners manual

- 9 -

System Ground Terminal

The H15 provides for the connection of grounding wires from

all of your equipment to a central terminal lug. This ground

connection eliminates ground loop problems; tie all component

grounds to this screw to break any possible ground loops that

can cause an audible ‘hum’.

Circuit Breaker

The H15 also provides a “press-to-reset” circuit breaker. When

this breaker is “tripped” due to an electrical surge or overload,

the device pops out and shuts down output power to the outlets.

To reset the circuit breaker, push it straight inward.

Caution: When resetting the Circuit Breaker, push the button in

quickly, and release the button. Do not hold the button inward.

Failure to comply may result in equipment damage.

Input Power Connector

Connect one end of the supplied AC power cord to the H15

Input Power Connector, connect the other end to the AC utility

power source (12 Amp, 120 Vac, 50-60 Hz).

DC Trigger jacks

When connected to a component acting as a DC trigger, that

component controls turn on/off of the ‘delayed’ outlet banks.

The H15 also allows that DC signal to pass through to another

connected component.

CAUTION: When connecting to the DC Trigger jacks, connect

the source of the DC trigger to the IN jack. The OUT jack

should be used only as a pass-through. The DC Trigger signal

can be short circuited if the input and output cables are

reversed. The maximum input voltage for the DC Trigger is

30VDC. Do not apply an AC voltage to the DC trigger jacks.

Failure to comply with this statement may result in equipment

damage.